Wednesday, 9 April 2014
KILL Wax Moth with a heat gun. Quick, easy and cheap.
A short video on how we sometimes resort to using a 600 degrees Celsius heat gun on old frames before we replace the foundation. This process not only wax coats the timber to protect it from rotting as easily and prolong its life in general, but it also kills Wax Moth and Hive Beetle eggs, and a host of other undesirable parasites. Its just one of many ways to do it, but this one is fast and relatively safe rather than using a blow torch or open fire on timber that is coated with wax, which is somewhat a fire hazard really. Hope you enjoy our videos, and if you do, please subscribe and let us know if you have any questions or suggestions about each video or the channel in general. All feedback is much appreciated. Thank you
A great article and many more like it are online, but this is a nice summary on wax moth and beekeeping if you would like to learn more. It is published by http://www.beeworks.com/:
A normal healthy hive will keep wax moth under control by ejecting the larvae, but weakened hives with small populations can be overcome by wax moth infestations destroying the brood comb, ultimately destroying the hive.
There are two varieties of moth which take delight in dining on wax the 'Greater' and also the 'Lesser' Wax Moth the greater wax moth is a mottled grey in colour approx 1 -1B= inches in length while the lesser is smaller and slimmer approx B= inch in length and white/silver. As all moths, they prefer night time to mate and lay eggs. (Photos are available in our picture gallery.)
Most wax moths are seen in early summer in our area, and we see them under the overhang of hive roofs, out of the daylight, when the hive is disturbed they take off quickly and disappear into the trees.
Preferring to work in the dark the moths enter the hive through top entrances left unscreened and unguarded by the bees, perhaps a sudden cold snap making the bees cluster, and lay eggs in cracks unavailable to the bees. These hatch in due course and the grey larvae begin feeding on wax and hive debris, tunneling just under the cell caps and feeding on the discarded cocoons left by the bees, leaving behind an extremely sticky white web, similar to spiders web but almost impossible to pull apart. So perhaps they are misnamed and should be called Cocoon moths?
With a little care wax moth can be outwitted and the damage they do can be prevented.
First, the practice of top entrances should be examined, provided they have screening then there will be no problem. Leaving a big hole in the inner cover, then a badly fitting roof, is just asking for trouble. Or even worse those holes drilled in the top of boxes allowing the bees a second entrance are a real problem. Apart from pollen in the honey, a cold evening and the bees pull down and form a cluster leaving that entrance unguarded, easy pickings for the wax moth, as they will fly in cooler conditions than bees.
They do say that prevention is better than cure. I have already given one way, using screening to prevent wax moth entering the hive top. The second point could be to use a trap to draw the moths away from the hive area. There are, to my knowledge, no commercial wax moth traps, but we use a country cure which works extremely well and I would recommend to all.
Take a 2 litre plastic pop bottle and drill a 1 inch hole just below the slope on the neck, then add 1 cup water, 1 cup sugar, 1 half cup vinegar and finally 1 banana peel. Wait a few days till it starts to ferment, then tie it into a tree close to the hives. This trap will draw the wax moth, they enter the hole can't get out and drown in the liquid, this will even draw in and kill the bald faced hornet.
Assuming you have followed the above instructions, then you should be able to prevent damage, but what to do if you have already a problem of wax moth?
Extensive damage, evidenced by the white webs, might be simpler to burn and start again. In cases of minor infestations pull out any larvae you can see and clean out all webs. Freezing is a very good way of killing larvae and eggs, so storage in an outside unheated shed during the winter can be useful. Boxes should have a screen top and bottom to prevent mouse damage and allow light to filter down as wax moth prefer the dark.
There are also preventative treatments to treat boxes of drawn brood comb if the above suggestions cannot be incorporated into your management regimes, there is no need to treat honey supers as they don't normally hold brood cocoons. One is a product called Certan, mixed with water and sprayed on the comb with a garden pressure sprayer. This is the only biological larvaecide available for wax moth control, it has no effect on you, your honey, bees or wax. Used just before storage or before the comb is placed on the hive it is ingested by the larvae and kills from the inside out.
The second treatment is placed onto the stacked pile of boxes during storage and consists of ParadiChlorBenzene crystals. These are used over newspaper in the stack, needs airing out before use.
Contrary to public opinion wax moth can be controlled, but I stress that prevention is better than cure, and the simplest way is to prevent wax moth getting into the hive through gaps and spaces.
Music composed, performed and provided by Groovey - Adam Kubát a Pavel Křivák
You can visit their website on: http://www.groovey.cz/
Posted by Mahako Bees